Scott Musman : May 1993

	The tar'd & gzip'd files clx-p1.tar.z and clx-p2.tar.z contain
both source and object files for CLX and PCL for AKCL under Linux. The
object files are included for your convenience to save time and effort
during the installation. 
	You will need ~14Mb to install the included sources
confortably. Unziped each tar file is just over 3Mb. Collectively they
are close to 7Mb. After they have been loaded into AKCL the resultant
saved-image is also about 7Mb (this implies something about how well
CLX will run if you do not have much RAM). After you have created a
saved image you can delete the sources, so it is possible to use less
disk space by doing some file juggling.  

	To install the CLX files follow the instructions given
below: 

	unzip the installation files by typing
		gzip -dc clx-p1.tar.z > clx-p1.tar
	for each file.

	Untar the archives
		tar xvf clx-p1.tar
	it will create it's own subdirectory.

	Then simply follow the directions specified in the README file
found in the top CLX directory created by untarring the above
archives. 

	Should you ever have to recompile the source code you may
simply make a copy of the load-clx.lsp file and replace the word
"load" with "compile" for the commands "pcl::load-pcl" and "load-clx".
Compilation will take quite some time, and the warnings generated during
the compilation are "normal".

	Please let me know if you have any troubles with the
installation procedure or with CLX.

		-- Scott
		musman@ai.mitre.org